I wonder if everyone is still satisfied with the performance of the gearbox after purchasing it? Today, the editor has specially compiled "18 tips" about the use of reducers for everyone. What are the "tips" exactly? Next, let me take you to learn about it together.
1. The reducer does not have self-locking function.
2. Equipment should be equipped with overload protection devices in situations where overload may occur.
3. In situations where the machine base and foundation are subjected to impact, vibration, or frequent starting, in addition to using foot bolts for connection, positioning pins (self provided) should also be used for reinforcement.
4. The reducer can be adjusted with cushion blocks during installation, and the cushion blocks should not exceed three in the height direction. Of course, wedge iron can also be used for adjustment, but after machine calibration, it is important to replace them with flat cushion blocks.
5. The output shaft of the device cannot withstand axial force.
6. Pay attention to the installation angle freedom of the cycloidal pinwheel equipment lubricated with grease.
7. When using a coupling to connect the cycloidal pinwheel reducer with the corresponding mechanical connection, it is recommended to use an elastic coupling.
8. When the equipment is connected to the matching mechanical coupling, the coaxiality of the two axis lines shall not exceed the allowable range of the coupling.
9. After installation and before formal use, it is important to conduct a trial run and gradually load and operate under normal no-load conditions.
10. When using sprockets for transmission, do not loosen the gear chain too much, otherwise it will generate impact force during starting.
11. The output shaft of a single-stage gearbox rotates in the opposite direction to the input shaft, but the output shaft of a two-stage gearbox rotates in the same direction as the input shaft.
12. This device is suitable for 24-hour continuous work and allows for forward and reverse operation.
13. The plate type horizontal cycloidal pinwheel equipment should be installed on a very sturdy horizontal foundation without vibration.
14. The Lan style vertical cycloidal pinwheel reducer has its output shaft vertically downward during installation.
15. When special installation forms other than foot plate horizontal installation and flange vertical installation are required, corresponding lubrication and sealing measures should be taken to ensure sufficient lubrication and prevent oil leakage.
16. The input shaft and output shaft of the standard cycloidal pinwheel reducer are cylindrical in shape and connected by ordinary flat keys.
17. When connecting the reducer coupling, gears, sprockets, and other connecting components to the output shaft of the cycloidal pinwheel equipment, direct tapping should not be used. Instead, bolts should be screwed into the shaft extension end screw hole and pressed in through a pressure plate.
18. When the cycloidal pinwheel reducer is connected to gears and sprockets, it is important to ensure the parallelism of their axis lines.
The above is all the content of the 18 instructions for using the reducer. We hope it can provide effective help for everyone's future installation and use!
Language
